Radio Engineering Industries Digital BUS-WATCH Bedienungsanleitung PDF herunterladen (Seite 7)

Digital BUS-WATCH

Radio Engineering Industries, Inc.

640289

Rev B -- 11/18/2002

System Installation

System Wiring

Note: All cables should be hidden from view.

For the basic system (shown in Fig. 2), there are two cables; power (510880) and

camera (510781). For additional vehicle monitoring, the BUS-WATCH® Options

harness (511617) is available.

Connect the camera using cable P/N 510781. There is no specific orientation for this

cable to be installed.

Connect power using cable P/N 510880. The black wire connects to the negative

terminal of the battery. The green wire (labeled 12V MEM) connects directly to the

positive terminal of the battery. The green wire should be fused at 4 A.

• IF THE SYSTEM OPERATES IN THE MANUAL RECORD MODE, connect the

red wire (labeled 12V SW), to the switched side of the ignition switch. The red

wire should be fused at 1 A. The red wire is disabled if the system is in TIMER

record mode.

Figure 2

Note: Green wire fused @ 4 A, Red wire fused @ 1 A

*Connect GREEN wire DIRECTLY

to the positive terminal of the

battery.

*Connect BLACK wire DIRECTLY

to the negative terminal of the

battery.

WARNING

REMOVE VEHICLE BATTERY VOLTAGE BEFORE INSTALLING

SYSTEM WIRING

1 2 3 4 5 6 7 8 9 10 11 12 ... 29 30

Keine Kommentare

Radio Engineering Industries Digital BUS-WATCH Bedienungsanleitung Seite 7