Radio Engineering Industries SD40 Bedienungsanleitung PDF herunterladen (Seite 27)

Digital BUS-WATCH

HDx00

Page 27 of 85

Radio Engineering Industries, Inc.

640430 -- Rev 0 -- 1/12/2012

The default TRANSIT monitored points in the vehicle are:

• Vehicle speed

• Brake activation

• Warning lamp operation (de-acceleration lights)

• Turn signals

• Front door switch operation

• Back door switch operation

• Optional point with Auxiliary (Aux 1 is user-defined and may be used to

monitor points such as wheelchair lifts, inertia sensors, etc.)

The CUSTOM vehicle sensor option allows for most other situations. The letters

that appear on the screen are settable through the menu system. The default settings

are blank.

When using these options, the DEFAULT condition is that the Digital BUS-

WATCH® considers a low voltage (or ground) in the OFF state. A high voltage (5-

15 VDC) is interpreted as the ON state. To switch the polarity of these signals,

reference the Vehicle Sensor Levels Options menu page as shown in Error!

Reference source not found. on Page Error! Bookmark not defined..

Speedometer Harness Wiring Instructions

The BUS-WATCH® speedometer input wires are designed to be spliced directly

onto the transmission speedometer transducer wires. In some installations, this may not

be possible (i.e. mechanical speedometer, transmission manufacturer warnings, etc.). The

BUS-WATCH® Vehicle Speed Sensor Kit (P/N 750086) may be required.

Refer to the vehicle service manual for speedometer type, exact wire

location, and transmission manufacturer warnings.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 84 85

Keine Kommentare

Radio Engineering Industries SD40 Bedienungsanleitung Seite 27